If there is a ground screw and it is not connected to the neutral with a strap or wire, follow the manufacturer's wiring diagram to make the proper ground-to-neutral connection. The wire makes an internal connection to the neutral. If there is a ground screw and it is connected to the neutral (center) terminal with a metal strap or small, white wire, leave the strap or wire in place. If there is no ground screw, no alteration is necessary. This is an internal neutral connection you will connect it to the neutral terminal along with the neutral cord wire just to keep it safely secured (it won't serve a purpose). If there is a small white wire connected to the ground screw, remove it from the ground and fit it onto the neutral terminal on the block. If there is a ground screw and it is connected to the neutral (center) terminal with a metal strap, remove the strap from the neutral terminal on the terminal block (you can remove the strap entirely or keep it attached under the ground screw). If there is no connecting strap or wire on the ground screw, the range is ready for the four-prong cord. If necessary, alter the ground-to-neutral connection as needed, depending on the type of cord you are installing: There may or may not be a ground screw near the terminal block-if present, this will be driven into the metal case of the appliance. There are three terminals in a line: the center terminal is neutral and usually has a white wire the left terminal is hot and may have a red or black wire the right terminal also is hot and may have a black or red wire. Note the wiring configuration on the terminal block.
Alter the Ground Connection, If Necessary.The Spruce Home Improvement Review Board.When lowering it, make sure it snaps over the clips. Release the 2 front clips with a large flat blade screwdriver and remove the 4 screws under the burner heads. Watch for the self-clean light to turn off (on models with knob controls) or for the timer to display 0:00 (on models with push-pad controls). NOTE: If an orifice spud is accidentally dropped, the cooktop can be raised. Put old orifice spuds back in the bag or on the bracket next to the pressure regulator to save for possible future conversion. To prevent leakage, make sure the orifice spuds are securely screwed into the gas inlet tubes. To convert to natural gas, loosen the spud about 2 turns.Ĥ. To prevent damage, do not overtighten spud. Tighten spud only until it is snug with the base. Turn the upper burner orifice spud clockwise.
To convert to natural gas, loosen the spud about 2 turns. To prevent damage, do not overtighten the spud. Turn the lower burner orifice spud clockwise. (On some models, a metal shield must be removed to access the orifice.) 2. The lower burner orifice spud is located behind the storage drawer, broiler drawer or kick panel. Remove oven door, storage drawer or broiler drawer and oven bottom. Or Converting Back to Natural Gas from LPġ.
0 kommentar(er)
